If your exterior is wood, all you need to do is drill pilot holes using a drill bit that’s a tad smaller than the included screws.Īfter that, screw in the mounting plate using the included screws. If the exterior of your house is brick or masonry, you’ll need to use the included drill bit to drill holes where you made marks, and then insert in the two yellow wall anchors before screwing on the mounting plate. Grab the mounting plate that came with your SkyBell and hold it up to your exterior wall where you want the unit to be mounted, and mark with a pencil where the two mounting screws will be drilled. At this point, your doorbell wires are ready to go. Loosen these screws and remove the two wires from the doorbell button. ![]() ![]() There will be two small wires connected to the back of the doorbell and they’ll be connected by small screws.
0 Comments
Leave a Reply. |